Omnimount PMD1 Manual de usuario descargar pdf (Pagina 2)

Models: PMD.5 — PMD1 — PMD2

Part Description Qty.

Mount Assembly Hard-

ware

A Top Projector Plate 1

B Bottom Projector Plate 1

C Pipe Drop Assembly 1

D Plastic Cover 1

E Ceiling Plate 1 Bag

F Hex Screw: ¼”-20 X ¼” 1 (d)

G Screw: ¼”-20 X 3/8” 2 (c)

H Hex Screw: ¼”-X 5/8” 4 (d)

I Hex Screw: ¼”-X ½” 6 (d)

J Lag Bolt: 5/16” X 3” 4 (e)

K Plastic Plugs 14 (b)

Hex Wrench 1 (d)

Step 5

Slide the bottom projector mounting plate onto

the previously installed top projector mounting

plate. (Fig. 11)

Note: Make sure that the cables don’t get

pinched while sliding the plates together.

Important: Always secure projector plates by installing 3/8”

screws (G) into holes on front edge of plates.

Additional security can be provided by installing small pad-

locks through security slots at the rear of the projector plates.

(Fig. 12)

Fig. 11

Fig. 12

Attach cables to the projector. Turn projector ON, and make pitch

and keystone adjustments as per the projector manufacturers

instructions. For additional pitch/tilt, use the three adjustment

knobs on top of the PMD mount (Fig. 13).

Fig. 13

1 2 3 4

Sin comentarios

Omnimount PMD1 Manual de usuario Pagina 2